Article 2.0.1G : A meter 21.75 Gwh received value not display in modscan for float datatype

A meter with RD option, 21.75 Gwh received value is displayed as ???? in modscan. Register address is 159.
Which is displayed correctly in modbus poll as, where 2.175E+010 means 2.175*10^10(E=10) when decimal point is shifted towards right it becomes 21.75*10^9 which is 21.75Gwh.
For clarification refer images attached.

Related Articles
Article 4.11.1F : Programming range and Full scale display of ADC & VDC meter.
Please find the below image of the backside of ADC & VDC. the input of ADC and VDC is shown in SR No sticker it should be selected by the customer as per requirement. Vin or I/P will be shown in Sr no sticker. Standard input and programming range is ...
Article 4.3.1K : Why the balance is reducing when prepaid meter automatically reset?
When KVA value reaches maximum value, meter will automatically reset to 0. When the meter resets, balance is also reducing which should not happen. In such case, firmware needs to be updated (to version 3.09) in that prepaid meter. Note: This is ...
Article 4.17.2 K: While EPC Meter 1st analog is displaying correct value and 2nd Analog value is incorrect in Modscan/Modbus poll.
While verifying the both inputs on Modscan/Modbus poll its displaying: The reading of one of the analog input is displaying the correct value while for other analog input its displaying greater than the actual. However, while connecting a single ...
Article 4.11.1.H : How to connect 3 Phase Amp meter and 3 Phase Kwh meter with common RYB CT?
Yes, we can connect 3 Phase Amp meter and KWH meter with the same CT. not need of separate CT for both meters. The same RYB CT's may connect to both meters for measurement. Please do the connection of CT to meters as explain below. R phase CT S1 ...
ATeS with LCD display Manual
Please refer to attached manual of ATeS with LCD display.

Related Articles