Recent Articles
How to resolve segment issue in Gen 2 ATeS.
1) Check and verify the incoming voltage at S1 and S2. 2) Remove the wiring harness from both sources. 3) Remove the four screws at each corner. 4) Install the new AteS LCD Controller and reconnect the wiring harness.
LG 6400DMC not showing the instant demand value
LG 6400DMC not showing the instant demand value Step-1:- Check the CT connection in the meter in Watts Parameter Like the image shown below STEP-2:- If the CT Get reversed means meter will shows minus in the watts parameter. If CT is get reversed ...
iACCL 400 Working and RS-485 Communication Status
iACCL 400 Working and RS-485 Communication Status Issue: Need to verify whether the iACCL 400 is working properly and communicating through RS-485. Troubleshooting Steps: Check the power supply to the iACCL 400. Verify that the device is powered ON ...
Programming Manual of iACCL A400
In ACCL A400, we can only monitor the DG current. Please find the attached manual.
MQTT Gateway GW 2000 configuration.
Elmeasure GW2000 MQTT gateway configuration. 1.Power ON the Gateway Use proper 5V DC power supply for stable operation. Connect Ethernet cable if using LAN mode. 2.Connect RS485 Network Connect all meters in RS485 chain. Check A(+) and B(-) polarity ...