Article 4.2.1F : Energy reading scaling ( Wh - Kwh - Mwh - Gwh) calculation

• Related Articles

• Article 4.1.1.3 : Why in EN meter only one phase PF & KW value comes very less and KWh consumption is less with reference main meter?

  Please find the below images of the EN meter display to understand the situation of a meter. As shown in the above images we can see in the Y phase PF & KW is very less compare to the other two-phase. Here KW depends on the PF value because of PF ...

• Article 2.0.3T : When does energy reading will reset automatically ?

  According to the following condition most of our energy readings will reset automatically. But readings will be shifted to old page. PT Ratio * CT Ratio *10^7 *Ave.Power Factor = units (ie: Mwh or Kwh) in TM(with MSP 148) 999999*kVAh*multifunction ...

• Article 4.11.1.H : How to connect 3 Phase Amp meter and 3 Phase Kwh meter with common RYB CT?

  Yes, we can connect 3 Phase Amp meter and KWH meter with the same CT. not need of separate CT for both meters. The same RYB CT's may connect to both meters for measurement. Please do the connection of CT to meters as explain below. R phase CT S1 ...

• Article 4.2.12 : LG meter not gives accurate Kwh reading.

  If LG meter KWh reading consumption is not matched with actual consumption. Please check the following points as given. 1. First, check the CT connection ensure there is no loose connection. 2. Check the CT ratio set parameters with connected CT on ...

• Article 4.1.1E : EN Meter kWH reset Reading.

  1. The Reset for EN Meter will occur at (999999 kvAH * MF ) 2. MF is taken into consideration from kW calculation 3. kW calculation = (1.732*PT pri *CT pri)/1000 PT pri, CT pri at Full scale. Same MF to be selected for both RESOLUTION & COUNTER ...