Elmeasure GW2000 MQTT gateway configuration.
1.Power ON the Gateway
Use proper 5V DC power supply for stable operation.
Connect Ethernet cable if using LAN mode.
2.Connect RS485 Network
Connect all meters in RS485 chain.
Check A(+) and B(-) polarity properly.
Ensure meter IDs and baud rates are configured correctly.
ID start from 2 Onwards
3.Open Gateway Webpage
Connect laptop to same network.
Open browser and enter Gateway IP address.
Default IP is generally: 192.168.5.175
Login using default credentials if required.
4.Configure Communication
Add meters through Add devices put the id range.
Check other parameters such as date, time and data read out timings
Change the IP from default to Wi-Fi router series. and save all
Check Broker is connected or not.
5.Reset the Gateway
At backside of gateway there is tiny thin hole is there press it through pin for 20-30 sec it will now open the by default
page of the gateway on by default IP.