Article 2.0.2Z : What are the communication settings available in Elmeasure meters ?

• Related Articles

• Article 2.0.1Z : What are the protection standards in Elmeasure meters (MFM)?

  Elmeasure follows the Protection standard as per IEC 60529. IP 51 & IP 54 (Front option). IP51 Protected from limited dust ingress. Protected from condensation. IP54 Protected from limited dust ingress. Protected from water spray from any direction. ...

• Article 2.0.1H : Automatic reset in Elmeasure Meters ?

  There is no option to set the Energy meter reset at 1 MWh. There is no option to control the Energy readings. Our meters will reset as per the below method for both Auto Scaling and Counter Mode. 1. The Reset for any Elmeasure Meter will occur at ...

• Article 4.5.1A : Data pack required for GPRS communication

  Please find the attachment of the data pack details.

• Article 3.1.2W: Meter intermediate communication modscan (timeout error) and software

  Please find the attachment for the solution

• Article 1.0.1D : DO's and DONT's for Elmeasure Products

  DO's 1.Always, install safety Equipment's like Earth leakage / overload & short circuit protection [circuit breakers / switches ] near point of supply. 2. Use lugs to connect the electrical wires to the meter while installing. ...