Article 4.30.1A : Remote Display Unit (RDU)

• Related Articles

• Article 4.19.32S : How to enable or disable phase sequence Trip in ATes by the remote display?

  In ATes, There is an option to enable/disable the Phase Sequence tripping mode. By default, it's on disable it can be changed as per the customer requirement. In Ates Remote display E14 is by default 000 (Disable) need to change to 001 (Enable) for ...

• Article 4.4.1E : Settings for communicating Transparent gateway in remote

  Find the attachment for configuring the communication in remote

• Article 4.17.2 M: If EPC meter is not allowing writing the frequency parameter then what should be replaced? Main Unit or DI/AI Module

  In such condition replace priorly Main unit as DI/AI module has feasibility to work with any main unit.

• Article 4.11.1F : Programming range and Full scale display of ADC & VDC meter.

  Please find the below image of the backside of ADC & VDC. the input of ADC and VDC is shown in SR No sticker it should be selected by the customer as per requirement. Vin or I/P will be shown in Sr no sticker. Standard input and programming range is ...

• Article 4.17.2G How to Check EPC Meter DI Status on Meter Display?

  1) Press Down Key untill D1, D2, D3, D4, D5 & D6 are not displayed on screen. 2) It will display the status of DI -> ON/OFF (Refer the Image)