Article 2.0.1A : What are the Elmeasure range of products?

Article 2.0.1A : What are the Elmeasure range of products?

  1. EMS (Software),
  2. Demand Controller,
  3. Multifunction meters,
  4. Load Managers,
  5. Dual Source Energy meters,
  6. Power Factor controllers ,
  7. Earth Leakage Relays ,
  8. Motor protection system,
  9. Power Distribution Unit,
  10. RS485/232 converters,
  11. Prepaid energy meters.

    • Related Articles

    • Article 2.0.1Z : What are the protection standards in Elmeasure meters (MFM)?

      Elmeasure follows the Protection standard as per IEC 60529. IP 51 & IP 54 (Front option). IP51 Protected from limited dust ingress. Protected from condensation. IP54 Protected from limited dust ingress. Protected from water spray from any direction. ...

    • Article 1.0.1D : DO's and DONT's for Elmeasure Products

      DO's 1.Always, install safety Equipment's like Earth leakage / overload & short circuit protection [circuit breakers / switches ] near point of supply. 2. Use lugs to connect the electrical wires to the meter while installing. ...

    • Article 3.2.1M : How to change logo in Elnet PPS report?

      Go to C:\Program Files\Elmeasure\ElNet PPS\webapps\elnetpps\resources\images (Root folder of Elnet PPS). In Images folder, Replace Logo.jpeg with your logo. Format must be .jpeg & recommended resolution is 403x96. *** End of article *** 

    • Article 2.0.1H : Automatic reset in Elmeasure Meters ?

      There is no option to set the Energy meter reset at 1 MWh. There is no option to control the Energy readings. Our meters will reset as per the below method for both Auto Scaling and Counter Mode. 1. The Reset for any Elmeasure Meter will occur at ...

    • Article 3.7.1J : Powerstudio software for ID Logger 8000.

      Kindly click the link below to download "Powerstudio" software for ID Logger 8000. https://drive.google.com/open?id=13qtNZtP-0H8bX_vrDAMoeXN_FhhZbqTK *** End of Article ***