Check and configure APN settings

Navigate to the "Network" or "Internet" settings.
Look for the APN (Access Point Name) settings. For JIO, the APN should be set to jionet.
Ensure the APN settings are correct:
- APN: jionet
- Authentication Type: None
- PDP Type: IPv4
If there's an option for "PDP Type" or similar, ensure it's set to IPv4 instead of IPv6 or IPv4/IPv6.

Related Articles
Article 4.6.2A : How to check IPFC meter error in meter ?
Go to meter configuration and make it settings enable from 42 to 47 options to find error in meter, like under current, over current, under compensation, over compensation, over voltage, under voltage and other warnings.
Check Connection Mode
Ensure the connection mode is set to "Auto" or "LTE Only" depending on your router's configuration options.
Article 3.6.1N : How to Check SQL Version and Edition using command and GUI ?
Attached document to check sql version and edition
Article 2.0.1P : How to check the communication via MODBUS ?
To check the communication via MODBUS, kindly follow the below mentioned steps. 1. Open MODBUS poll software. 2. Open Connection & select Connect. Here you have to select TCP/IP mode & select your Port number (Ex: com port8) and Click Ok. 3. Open ...
Article 3.1.2H : How to check when the System or Elnet Service has been stopped which results in Data missing in Elnet software?
If data is not logged in Elnet software, first check whether the system has gone to sleep mode or system has been switched off. Steps to check whether the system was in sleep mode : 1) Go to This PC or My Computer 2) Select Manage 3) Select Event ...

Related Articles