Article 2.0.1P : How to check the communication via MODBUS ?

Article 2.0.1P : How to check the communication via MODBUS ?

To check the communication via MODBUS, kindly follow the below mentioned steps.
1. Open MODBUS poll software.

2. Open Connection & select Connect.

Here you have to select TCP/IP mode & select your Port number (Ex: com port8) and Click Ok.

3.  Open Poll Definitions,

 Enter Slave ID (Device ID) - (as you configured in the meter)

 Function - 03 Reading Holding registers

 Address - 101

 Length - 124

 Scan rate - 100ms. Click apply & Ok.

4. After completing Poll definitions setting, You will get your data using Modbus Poll. 

5. Go to Display and in that select Float. Now all data is showing.

    NOTE: To check the Parameters correctly download the Modbus register Map from Elmesaure website.