Article 4.30.1B : RU 1000 : Display options

• Related Articles

• Article 2.0.3Y : Why voltage phase angle will display R=0, Y=240, B=120 ?

  Phase voltage may be interchanged.

• Article 4.8.1.17S : ACCL is not showing display and at EB incoming terminal of ACCL is not show the actual voltage in meter as if disconnected and check.

  Issue: The ACCL is not having a display and when the incoming supply at ACCL EB terminal checked with multimeter not getting the proper voltage and coming 8.0 V R Phase to neutral, Y & N is 440, B & N is 440.  Also checked at the incoming 4 pole MCB ...

• Article 4.11.1F : Programming range and Full scale display of ADC & VDC meter.

  Please find the below image of the backside of ADC & VDC. the input of ADC and VDC is shown in SR No sticker it should be selected by the customer as per requirement. Vin or I/P will be shown in Sr no sticker. Standard input and programming range is ...

• Article 4.17.2G How to Check EPC Meter DI Status on Meter Display?

  1) Press Down Key untill D1, D2, D3, D4, D5 & D6 are not displayed on screen. 2) It will display the status of DI -> ON/OFF (Refer the Image)

• ATeSLCON100: Wiring Diagram to Switch on the Inbuild Display

  Please find the attached wiring diagram for your reference. Additional control wiring required to switch on the ATeSL inbuild display