3.1.1 Theiox 2.0
DG Selection and Meter Setup using Theiox software.
Kindly review the screenshot of the setting below and ensure that the DG Selection is set to "No DG." Additionally, please configure it to the meter by initiating the write command so that, when there is a DG supply to the meter, the output supply ...
Verify the Internet connection
After the router restarts, check if the internet is now working over IPv4. You can verify this by checking the IP address on your connected device: Open a browser and go to a site like ipinfo.io or whatismyip.com to see if your IP address is IPv4.
Reboot the router
Save your settings and reboot the router to apply the changes.
Check Connection Mode
Ensure the connection mode is set to "Auto" or "LTE Only" depending on your router's configuration options.
Disable IPv6
Navigate to the "Advanced" or "Internet" settings section. Find the IPv6 settings and disable IPv6.