When KVA value reaches maximum value, meter will automatically reset to 0. When the meter resets, balance is also reducing which should not happen. In such case, firmware needs to be updated (to version 3.09) in that prepaid meter. Note: This is ...
Answer is No. We can only view how much balance left & not how many units left. For example - 1. one unit (1 kWH) tariff is 10/- 2. we recharge for Rs 100. then 10 units can be utilized. 3. in Meter we can view 100/- & decreasing balance as per kWH ...
How to make 'Low balance blink 0' in Modbus Poll? 1) In Modbus Poll Click on 'Setup' 2) Click on 'Read/Write Definition' 3) Enter the Address value as '6961' Quantity '2' (In general Slave ID should be entered with the particular ...
1. Polling interval time from MQTT Gateway to meter - It depends on no. of meters added to the gateway. For one meter every one min it will poll the data. 2. Data are not updating regularly from MQTT Gateway to elnet software - It is a wireless ...
whether we can recharge the different meters in loop with different unit slabs? This feature is possible in our standard software, Prepaid meters each can be programmed with Different slab rates.
1. Check meter is communicating with server. 2. In ELNet Customer Master verify for serial number is matching with connected meter serial no 3. Verify weather 2 meters are configured for same serial number