Article 2.0.3U : When we can connect repeaters in the channels?

• Related Articles

• Article 3.1.1U : What setup I need to install when I connect GW1000 & GW2000 in same server?

  In such case, GW2000 setup file should be installed in server PC. *** End of article ***

• Article 4.2.1E : How to connect AO (ANALOG OUTPUT) in meter.

  Example- LG 5110 with 1 Analog Output Connect 24 Volt  supply to end terminals marked as +24VDC & -24VDC- This will energies  the circuit Connect the terminals marked as 1 & -24VDC (Parallel wires) to the PLC- This will provide the Analog Output of ...

• Article 4.4.1B : How to Connect Modbus Poll S/W with GW1000.

  1. Open GW1000 Default Home page using its IP. 2. Enter default User name(admin) & Password(12345). After successfully login, You will get GW Home Page. 3. Go to Misc. Setting & Change protocol from MODBUS_RTU to MODBUS_TCP/IP. Now click Update. 4. ...

• Article 4.11.1.H : How to connect 3 Phase Amp meter and 3 Phase Kwh meter with common RYB CT?

  Yes, we can connect 3 Phase Amp meter and KWH meter with the same CT. not need of separate CT for both meters. The same RYB CT's may connect to both meters for measurement. Please do the connection of CT to meters as explain below. R phase CT S1 ...

• Article 3.1.1V : What is the purpose of Elnet DS?

  Elnet DS should be installed when you connect Prepaid meter with GW2000. Elnet DS is used to recharge the prepaid meter when it connects to MQTT gateway (GW2000). Note: Elnet DS is not required when Prepaid meter is connected to GW1000. *** End of ...