Article 4.7.2M : What is the trip time interval programmable in iELR?

• Related Articles

• Article 4.33.1E : What is the log time interval for LORA?

  If 500 device is connected to a gateway - 4 hours will be the log time interval. If 1500 device is connected to a gateway - 12 hours will be the log time interval. *** End of document ***

• Article 4.7.2A Breaker of connected iELR is not Tripping during manual Test.

  If Trip indication and command is displayed on the meter after manually tripped. Then Check the changeover of NO & NC of iELR with COM. If that also works then there is a problem in connected Breaker not in iELR. And, If NO & NC changeover not done ...

• Article 3.1.1.0: how to set datalog time interval in ElNet ver 5.3?

  We can set or change the Datalog time interval through ElNet Configurator. Go to ElNet > Configurator > Tools > Backup / Others > Datalog Interval Time. After setting the data log interval time restart the ElNet service. Please find the below image ...

• Article 4.7.2.6S : How many parameters data comes online of iELR in Elnet?

  Only the leakage current will be shown in register address 151. Another address 149 is a dummy. 1. Current R Phase 40151 = Leakage current of iELR 2.Current Average 40149 = Dummy 

• Article 4.7.2J : What are the technical specification of iELR for Input, trip time Input Current and CBCT inner diameter available relay contacts?

  Input current range from 60mA to 12A and trip time programmable from 300mS to 30Seconds. Inner diameters: 40mm,65mm,100mm,150mm ,200mm,250mm and 300mm.