Article 2.0.2U : What are all the parameters will come under Power group?

• Related Articles

• Article 2.0.4D : What is the purpose of Power Assist?

  Power Assist can be installed between Meter & Gateway to avoid "240V AMF input". Existing method (before Power Assist) -  "240V AMF" input needs to be connected to the meter to detect the power as DG. New method (After Power Assist) - When power ...

• Article 4.6.2K : What is Leading and Lagging power factor?

  Lagging and Leading power factor When the current ‘I’ lags the voltage ‘V’ by an angle ‘θ’ is said to be as ‘Lagging power factor’ When the current ‘I’ leads the voltage ‘V’ by an angle ‘θ’ is said to be as ‘Leading power factor’. The figure which ...

• Article 2.0.2Y : What are all the parameters will come under basic group?

  VLL, VLN, A ( Average & Phasewise ) , Calculated neutral current, Frequency, RPM, V& A Phase angles & Unbalance Voltage and current.

• Article 3.1.1L : What are all the parameters will display in MIN & MAX reports ?

  BASIC ( VLL, VLN, A, F) & POWER( W, VA, VAR, PF) parameters.

• Article 2.0.3T : When does energy reading will reset automatically ?

  According to the following condition most of our energy readings will reset automatically. But readings will be shifted to old page. PT Ratio * CT Ratio *10^7 *Ave.Power Factor = units (ie: Mwh or Kwh) in TM(with MSP 148) 999999*kVAh*multifunction ...