Article 2.0.2V : What are the accuracy classes available in Elmeasure meters?

• Related Articles

• Article 2.0.1Z : What are the protection standards in Elmeasure meters (MFM)?

  Elmeasure follows the Protection standard as per IEC 60529. IP 51 & IP 54 (Front option). IP51 Protected from limited dust ingress. Protected from condensation. IP54 Protected from limited dust ingress. Protected from water spray from any direction. ...

• Article 2.0.1H : Automatic reset in Elmeasure Meters ?

  There is no option to set the Energy meter reset at 1 MWh. There is no option to control the Energy readings. Our meters will reset as per the below method for both Auto Scaling and Counter Mode. 1. The Reset for any Elmeasure Meter will occur at ...

• Article 2.0.2Z : What are the communication settings available in Elmeasure meters ?

  Baud rate, parity and device ID.

• Article 3.2.1M : How to change logo in Elnet PPS report?

  Go to C:\Program Files\Elmeasure\ElNet PPS\webapps\elnetpps\resources\images (Root folder of Elnet PPS). In Images folder, Replace Logo.jpeg with your logo. Format must be .jpeg & recommended resolution is 403x96. *** End of article *** 

• Article 2.0.2K : If CT polarity is reversed in Elmeasure meters, does meter show correct energy reading?

  Yes. Elmeasure energy meter has reverse lock option, so that energy will be accumulated always positive only.