Power assist

Power assist

 Where to connect power assist
In DG panel with looping of Rs 485 from meter which has DG supply.

How it will update software 
Through Lan cable looped to gateways and from gateways to software.

    • Related Articles

    • Article 2.0.4D : What is the purpose of Power Assist?

      Power Assist can be installed between Meter & Gateway to avoid "240V AMF input". Existing method (before Power Assist) -  "240V AMF" input needs to be connected to the meter to detect the power as DG. New method (After Power Assist) - When power ...
    • Article 4.6.2K : What is Leading and Lagging power factor?

      Lagging and Leading power factor When the current ‘I’ lags the voltage ‘V’ by an angle ‘θ’ is said to be as ‘Lagging power factor’ When the current ‘I’ leads the voltage ‘V’ by an angle ‘θ’ is said to be as ‘Leading power factor’. The figure which ...
    • Performance Assessment of Power Factor Capacitors.

      Voltage effects: Ideally capacitor voltage rating is to match the supply voltage. If the supply voltage is lower, the reactive kVAr produced will be the ratio V1 2 /V2 2 where V1 is the actual supply voltage, V2 is the rated voltage. On the other ...
    • Article 3.2.4A : Typical schematic for EB-DG changeover through POWER ASSIST.

      Kindly download the attached schematic diagram.
    • Causes of low Power Factor.

      Following are the causes of low Power factor: 1.  Single-phase and three-phase induction Motors. 2. Varying Load in Power System. 3. Industrial heating furnaces. 4. Electrical discharge lamps. 5. Transformers. 6. Harmonic Currents.