Article 3.1.2B : Why EBS is displaying wrong amount ?

• Related Articles

• Article 3.1.1Y : Why I couldn't generate reports in EBS?

  To generate reports, we need to install "Crystal Reports for .NET Framework 4.0" in PC. This setup is available in Elnet CD. Install 32bit or 64bit, according to PC specs. *** End of article ***

• Article 4.3.1E : Can we see how much units left instead of amount (Balance) in Prepaid meter ?- PE 5121,5120

  Answer is No. We can only view how much balance left & not how many units left. For example - 1. one unit (1 kWH) tariff is 10/- 2. we recharge for Rs 100. then 10 units can be utilized. 3. in Meter we can view 100/- & decreasing balance as per kWH ...

• Article 3.7.1D : What software I need to install to load amount in recharge card for prepaid meter?

  Install Elsoft PPS to load the amount into recharge card. *** End of article ***

• Article 4.17.2 K: While EPC Meter 1st analog is displaying correct value and 2nd Analog value is incorrect in Modscan/Modbus poll.

  While verifying the both inputs on Modscan/Modbus poll its displaying: The reading of one of the analog input is displaying the correct value while for other analog input its displaying greater than the actual. However, while connecting a single ...

• Article 4.1.1A : Zero is displaying in THD Y PHASE ?

  IF meter is connected with 3 CT and 3 phase and meter is programmed for DELTA then  A THD in Y PHASE Zero is displayed. How to over come A. Remove CT connected in Y phase  B. Let all the CT be connected set STAR in setup.