Article 4.7.2E : How will you test the ELR manually ?

• Related Articles

• Article 4.5.1I : Will GW2000 work in 4G network?

  No. GW2000 (MQTT gateway) will work only in 2G network (i.e - It will work only in 2G data mode). *** End of article ***

• Article 3.1.1F : How to configure Elnet E-mail protocol ?

  While configuring Devices in any of the Reports i.e Hourly report or Daily reports or any other, Device ID is to be added in ascending order ONLY. 

• Article 2.0.3V : When will Avg PF will be displayed in meter?

  If meter has Kvah parameter Ave.PF will be displayed.

• Article 2.0.3T : When does energy reading will reset automatically ?

  According to the following condition most of our energy readings will reset automatically. But readings will be shifted to old page. PT Ratio * CT Ratio *10^7 *Ave.Power Factor = units (ie: Mwh or Kwh) in TM(with MSP 148) 999999*kVAh*multifunction ...

• Article 2.0.1C : Why Elmeasure will suggest Belden Cable ?

  We will suggest Belden 3105A cable because the data transfer time is very good compare to normal cables. Stability of the communication also stands good in Belden 3105A cable. We can communicate the Energy meters uninterruptedly with out losing any ...