Article 3.1.1.0: how to set datalog time interval in ElNet ver 5.3?

We can set or change the Datalog time interval through ElNet Configurator.

Go to ElNet > Configurator > Tools > Backup / Others > Datalog Interval Time.

After setting the data log interval time restart the ElNet service.

Please find the below image for your reference.

• Related Articles

• Article 4.33.1E : What is the log time interval for LORA?

  If 500 device is connected to a gateway - 4 hours will be the log time interval. If 1500 device is connected to a gateway - 12 hours will be the log time interval. *** End of document ***

• Article 3.5.1B :PN/EN meter with MB (Datalog)

  1. What mode we need to set in gateway page when download data from meter?    We need to set RTU mode instead of TCP mode. 2. What is the RS485 time out set on gateway page?     100ms. 3. Is there any new software for datalog?    Yes, version 4 will ...

• Article 3.1.1R : Is it possible to sync time from PC to meter (RTC) via Elnet software?

  Yes. It is possible. It's not available by default but we can customize the software to sync time (RTC). RTC - "Real Time Clock" *** End of article ***

• Article 3.1.1O : What is Elnet Lanview?

  Elnet Lanview is a replication of Elnet software with a limited features. In Lanview, only three modules are available. i.e - we can view Online, Datalog & Reports.  What is the purpose of Elnet Llanview? Let's say, we have installed Elnet v5.3 ...

• Article 3.1.1P : How to install Elnet Lanview?

  Step 1 : Ping the server PC IP address from the Lanview PC & vice versa. Step 2 : Find Elnet Lanview setup in Elnet CD & Install it. Step 3 : GIve permission as "Everyone" to the root folder of Elnet Lanview. Step 4 : After installation, when opening ...