Article 4.1.1E : EN Meter kWH reset Reading.

1. The Reset for EN Meter will occur at (999999 kvAH * MF )

2. MF is taken into consideration from kW calculation

3. kW calculation = (1.732*PT pri *CT pri)/1000

PT pri, CT pri at Full scale.

Same MF to be selected for both RESOLUTION & COUNTER mode.

Related Articles
Article 4.1.1.3 : Why in EN meter only one phase PF & KW value comes very less and KWh consumption is less with reference main meter?
Please find the below images of the EN meter display to understand the situation of a meter. As shown in the above images we can see in the Y phase PF & KW is very less compare to the other two-phase. Here KW depends on the PF value because of PF ...
Article 4.11.1.H : How to connect 3 Phase Amp meter and 3 Phase Kwh meter with common RYB CT?
Yes, we can connect 3 Phase Amp meter and KWH meter with the same CT. not need of separate CT for both meters. The same RYB CT's may connect to both meters for measurement. Please do the connection of CT to meters as explain below. R phase CT S1 ...
Article 4.4.1D : How to reset gateway IP Address to default
By default, Gateway's IP address is 192.168.5.175. This G/W IP can be changed according to customer's requirements (i.e network range). In some cases, if customer lose the new IP address; they can reset the G/W IP address to default. Please find the ...
Article 4.1.1I : How to reset Elmeasure meter?
Kindly find the attached video.
Article 2.0.23S : Why is the kW (Active Power) showing a negative reading on the meter?
Consumption Load If users are metering a load that is consuming energy, seeing negative power (kW) readings would cause errors when reading the total consumed energy on the meter. Negative readings can be a result of the following: CT reversal: If ...

Related Articles