Article 2.0.1C : Why Elmeasure will suggest Belden Cable ?

• Related Articles

• Article 2.0.1Z : What are the protection standards in Elmeasure meters (MFM)?

  Elmeasure follows the Protection standard as per IEC 60529. IP 51 & IP 54 (Front option). IP51 Protected from limited dust ingress. Protected from condensation. IP54 Protected from limited dust ingress. Protected from water spray from any direction. ...

• Article 3.2.1M : How to change logo in Elnet PPS report?

  Go to C:\Program Files\Elmeasure\ElNet PPS\webapps\elnetpps\resources\images (Root folder of Elnet PPS). In Images folder, Replace Logo.jpeg with your logo. Format must be .jpeg & recommended resolution is 403x96. *** End of article *** 

• Article 3.2.1K : I replaced an existing prepaid meter with new one but couldn't recharge, why?

  Once you replace the prepaid meter, you can set the same device ID as before but couldn't recharge the meter. You can't recharge the meter because the new prepaid meter have different serial number. To solve this, Go to customer master, read the ...

• Article 2.0.1H : Automatic reset in Elmeasure Meters ?

  There is no option to set the Energy meter reset at 1 MWh. There is no option to control the Energy readings. Our meters will reset as per the below method for both Auto Scaling and Counter Mode. 1. The Reset for any Elmeasure Meter will occur at ...

• Article 4.5.1I : Will GW2000 work in 4G network?

  No. GW2000 (MQTT gateway) will work only in 2G network (i.e - It will work only in 2G data mode). *** End of article ***