Avoid meter terminal melting & precautions.
Please find below clarification to avoid cable burning at our meter terminals.
Related Articles
Article 2.0.23S : Why is the kW (Active Power) showing a negative reading on the meter?
Consumption Load If users are metering a load that is consuming energy, seeing negative power (kW) readings would cause errors when reading the total consumed energy on the meter. Negative readings can be a result of the following: CT reversal: If ...Article 4.11.1.H : How to connect 3 Phase Amp meter and 3 Phase Kwh meter with common RYB CT?
Yes, we can connect 3 Phase Amp meter and KWH meter with the same CT. not need of separate CT for both meters. The same RYB CT's may connect to both meters for measurement. Please do the connection of CT to meters as explain below. R phase CT S1 ...Article 4.3.1K : Why the balance is reducing when prepaid meter automatically reset?
When KVA value reaches maximum value, meter will automatically reset to 0. When the meter resets, balance is also reducing which should not happen. In such case, firmware needs to be updated (to version 3.09) in that prepaid meter. Note: This is ...Article 4.11.1F : Programming range and Full scale display of ADC & VDC meter.
Please find the below image of the backside of ADC & VDC. the input of ADC and VDC is shown in SR No sticker it should be selected by the customer as per requirement. Vin or I/P will be shown in Sr no sticker. Standard input and programming range is ...Article 4.3.1E : Can we see how much units left instead of amount (Balance) in Prepaid meter ?- PE 5121,5120
Answer is No. We can only view how much balance left & not how many units left. For example - 1. one unit (1 kWH) tariff is 10/- 2. we recharge for Rs 100. then 10 units can be utilized. 3. in Meter we can view 100/- & decreasing balance as per kWH ...