Article 4.6.2.26S: Is APFC440 or iPFC is suitable for controlling PF for the Solar application.

• Related Articles

• Article 2.0.49S: Programming guide of iPFC

  Please go through the attachment

• Article 4.25.1A : Is OM1310 has PF?

  Yes, it has; but there is no LED indication for PF. One of our customer is confused whether it has PF or not as there is no indication for PF in meter. So, here is the Video (with / without load) for reference.

• Article 4.1.1.24S: PF value not show accurate in EN meters compare to reference meter.

  Solution: PF value depends on current and voltage phase angle. First, check the voltage Phase angle in the meter it should be 0, 120, 240.  and verify the CT and PT connection in meter accordingly RYB. An issue on the site: PF value does not change ...

• Article 4.6.1A : iPFC - Connection diagram

• Article 4.6.1.0 : Reverse Amp error in iPFC Relay.

  Please find the attached image of error in a relay below. This error generated due to improper CT connection is done. If 3CT connected first to make sure every CT S1 & S2 are connected accordingly. If an error did not resolve then check CT connection ...