Article 6.1.18S : Moxa N-Port Converter Manual.

• Related Articles

• Article 6.1.20S : What is a default password for Moxa NPort?

  The default password for NPort is: moxa If the firmware version of your NPort is lower than specified in a table, then there is no password for NPort Just press Submit in a web interface. ​

• Article 3.7.1E : Do I need to install any software for USB converter?

  Yes, If you use the USB converter (As shown below). Install, Usb to RS485 Converter software. Unless you install the software, you can't communicate the meter via this converter. *** End of article ***

• Article 6.1.19S : How to reset an Moxa NPort password?

  To reset a password and to recover NPort default settings, press Reset button and hold it for 5 seconds. There is no other way to restore the forgotten password of NPort.

• Article 3.1.1AD : 1883 port is not listening/established, how to solve it?

  Step 1 : Install mosquitto-1.4.9-install-win32 Step 2 : Copy "pthreadVC2.dll" in to the root folder of mosquitto. FYI - The purpose of installing mosquitto is to open 1883 *** End of article ***

• Article 3.1.4B : ELNet_WEB_Based_Software_EMS Manual - Updated

  What is the update? SEC reports is updated in this manual. Kindly find the attachment.