Article 4.6.2.2S : Advantages of iPFC440 power factor controller.

• Related Articles

• Article 2.0.49S: Programming guide of iPFC

  Please go through the attachment

• Article 4.6.2K : What is Leading and Lagging power factor?

  Lagging and Leading power factor When the current ‘I’ lags the voltage ‘V’ by an angle ‘θ’ is said to be as ‘Lagging power factor’ When the current ‘I’ leads the voltage ‘V’ by an angle ‘θ’ is said to be as ‘Leading power factor’. The figure which ...

• Article 4.6.1A : iPFC - Connection diagram

• Article 2.0.4D : What is the purpose of Power Assist?

  Power Assist can be installed between Meter & Gateway to avoid "240V AMF input". Existing method (before Power Assist) -  "240V AMF" input needs to be connected to the meter to detect the power as DG. New method (After Power Assist) - When power ...

• Article 4.6.1.0 : Reverse Amp error in iPFC Relay.

  Please find the attached image of error in a relay below. This error generated due to improper CT connection is done. If 3CT connected first to make sure every CT S1 & S2 are connected accordingly. If an error did not resolve then check CT connection ...