Article 4.17.2 J EPC meter Analog Input Parameter setup in Elnet configurator.

Please Refer to Image.

• Related Articles

• Article 4.17.2C : EPC Meter AI Configuration

  Analog Input Configuration In EPC 5110 D. --> Go to EPC Meter Setup Mode.  A) Change the Parameter dsbl.A.1  (Analog Input 1 parameter) Options: Disable / 0.to.20mA/4.to.20mA  B) Change the Parameter 1000.A.1 Range: 0.001 to 999 Mega (According to ...

• Article 4.17.2F EPC Meter Digital Input and Analog Input Supply.

     Meter Digital Input and Analog Input Supply 1)      Optional: Digital Input (5-24V), Analog input (4–20 mA / 0–20 mA). 2)      Digital Input programmable for high frequency (72000 RPM) or low frequency (6 RPM).  3)      ON and OFF time for ...

• Article 3.1.1V : What is the purpose of Elnet DS?

  Elnet DS should be installed when you connect Prepaid meter with GW2000. Elnet DS is used to recharge the prepaid meter when it connects to MQTT gateway (GW2000). Note: Elnet DS is not required when Prepaid meter is connected to GW1000. *** End of ...

• Article 3.1.1P : How to install Elnet Lanview?

  Step 1 : Ping the server PC IP address from the Lanview PC & vice versa. Step 2 : Find Elnet Lanview setup in Elnet CD & Install it. Step 3 : GIve permission as "Everyone" to the root folder of Elnet Lanview. Step 4 : After installation, when opening ...

• Article 3.1.1O : What is Elnet Lanview?

  Elnet Lanview is a replication of Elnet software with a limited features. In Lanview, only three modules are available. i.e - we can view Online, Datalog & Reports.  What is the purpose of Elnet Llanview? Let's say, we have installed Elnet v5.3 ...