Article 3.7.1E : Do I need to install any software for USB converter?

Yes, If you use the USB converter (As shown below).

Install, Usb to RS485 Converter software.

Unless you install the software, you can't communicate the meter via this converter.

*** End of article ***

• Related Articles

• Article 3.7.1D : What software I need to install to load amount in recharge card for prepaid meter?

  Install Elsoft PPS to load the amount into recharge card. *** End of article ***

• Article 3.7.1J : Powerstudio software for ID Logger 8000.

  Kindly click the link below to download "Powerstudio" software for ID Logger 8000. https://drive.google.com/open?id=13qtNZtP-0H8bX_vrDAMoeXN_FhhZbqTK *** End of Article ***

• Article 2.0.1Z : What are the protection standards in Elmeasure meters (MFM)?

  Elmeasure follows the Protection standard as per IEC 60529. IP 51 & IP 54 (Front option). IP51 Protected from limited dust ingress. Protected from condensation. IP54 Protected from limited dust ingress. Protected from water spray from any direction. ...

• Article 3.1.4A : ELNet Software User Manual

  Kindly refer the attachment.

• Article 1.0.1D : DO's and DONT's for Elmeasure Products

  DO's 1.Always, install safety Equipment's like Earth leakage / overload & short circuit protection [circuit breakers / switches ] near point of supply. 2. Use lugs to connect the electrical wires to the meter while installing. ...