Article : How to find an IP address from a known mac address?

Article : How to find an IP address from a known mac address?

§  Enter the run command press "Windows + R" wrote "cmd" and then search with"arp -a"' in cmd.
§  Use the arp with additional arguments to find the IP within the same network segment.
§  With the command “arp -a” you can see the ARP table and its entries recently populated by your computer with the broadcast ping.
In ph

Please find the below image for an example.

    • Related Articles

    • Article 4.4.1D : How to reset gateway IP Address to default

      By default, Gateway's IP address is 192.168.5.175. This G/W IP can be changed according to customer's requirements (i.e network range). In some cases, if customer lose the new IP address; they can reset the G/W IP address to default. Please find the ...

    • Article 2.0.22S : Ping: Transmit failed. General failure.

      Missing Default Gateway If the default gateway entry is missing, the message “General failure” could appear. This happens, when the computer tries to reach a host outside it´s own subnet. There is no route to the destination. To keep it simple: The ...

    • Article 2.0.21S : Why do I get Request Timed Out when trying to ping a computer or Gateway?

      In most cases, a "Request Timed Out" message is caused by a firewall blocking the connectivity. Before you can ping, you'll need to ensure that the target machine has a green status indicator. If this is not the case, search our knowledge base for ...

    • Article 4.5.1D : What are the Gateway Return Codes for GW2000 (MQTT) ?

      You can find this type of codes in Elnet MS log's. For example - "LOG-ts 2019-07-12 13:46:37.406: SITE-ID 003055127E68 || DEV-ID || GW-TS 2019-07-11 09:02:00 || LIVE-LOG-STS LOG || REC-STS ks ACK-STS 07" In this case, 07 is gateway return code; now ...

    • MQTT Gateway GW 2000 configuration.

      Elmeasure GW2000 MQTT gateway configuration. 1.Power ON the Gateway Use proper 5V DC power supply for stable operation. Connect Ethernet cable if using LAN mode. 2.Connect RS485 Network Connect all meters in RS485 chain. Check A(+) and B(-) polarity ...